need feedback on my belt

[Guest Anonymous]

Hey I submitted my photos for my nihilus to get approved and I was told the rivets need to be in the middle but in the COTF reference pic on here it shows above and below the center belt and I was told my belt was wrong in size but my big belt is 2 1/2" and smaller one is approx just over 1/2, maybe around 3/8" (?).

On the 501 board it says "The belt is made from two layers of black leather. The base layer should be approximately 5 cm wide, (2") while the narrow strap on top should be approximately 1.2 cm wide. Pairs of black rivets are used to hold the smaller belt in place, and the belt must close in the back."

 

And I don't see where it says the rivet needs to be in the center.

Here is a pic below of my belt as I would like to hear your feedback.

reference picture

[Guest Anonymous]

I saw the exact same thing in the Nihilus drawing, that is that there are black rivets placed under and above the small belt, on the bigger belt.

 

My belt is based on that same idea.

http://sphotos.ak.fbcdn.net/hphotos-ak- ... 2557_n.jpg

 

I'd also like to hear more about this.

[Scottrooper]

Your belt looks great

 

The important question is: where did you find the black posts? I've never had any luck finding them for sale anywhere....

[Guest Anonymous]

Great belt! I'm working on mine. Where DID you find those studs?!

 

DC

[Drago Lordist]

that's pretty much how mine looks... was it your local GML that said this?

 

Thomas can correct me on this, but it doesn't look like it ever went throught the EU review thread...

[Guest Anonymous]

Looking good.

[Guest Aysel]

Where did you get the studs?

 

I'd like to know this as well. and yea your belt looks great

 

Katie

[Twi'lek Pam]

We ended up using these (large size) on Scott's new belt, and spray painted them flat black:

 

http://www.tandyleatherfactory.com/en-u ... 0-007.aspx

 

 

Pam