Jump to content
  • Announcement

    Welcome to the forums!

    If you are a newly-approved member, make sure you check out the New Member Checklist!

    If you are a Detachment member and can't see the member-only area, post here for access.

    -DV

Starkiller Costume Standards - Red/Black Sith Robes


Twi'lek Pam

Recommended Posts

.

 

 

To see the official Legion CRL entry and a downloadable PDF file for this costume, please click here:

 

http://www.501st.com/databank/Costuming ... clipse_CRL

 

 

 

 

Costume Standards for Starkiller's Red/Black Sith Robes

 

 

SithRobes2.jpgSithRobes1.jpg

 

 

Costume components:

 

1. Cloak: The hooded, sleeveless cloak is made of black fabric that reaches the ankles. The inside of the cloak and hood are lined with a deep red fabric, and the hood is always worn over the head. The cloak is secured closed on the chest, at a point directly under the base of the throat armor.

 

 

2. Hair: The costumer’s hair is dark brown, and is cut very short. Note: If the costumer's hair is well-concealed by the hood at all times, a very short cut is not required.

 

 

3. Armor Padding: Heavy black padding is worn under the chest armor. This fitted padding covers the chest, shoulders, upper back, and it has a high neck. There is a slit that remains slightly open at the front of the throat, while the padding over the chest is secured closed.

 

 

4. Throat Armor: The silver throat armor rests at the base of the neck. It is designed with a curve that goes up and around the throat, and there is a square shaped notch taken from the top center. The armor is attached to the padding from the back side, and has no visible attachment points on the front.

 

 

5. Chest Armor: The silver chest armor is made from two pieces that are mirrored in shape. Each piece has a gentle curve to follow the shape of the chest, and they are made with a material that gives the appearance of solid, sturdy armor. The armor is attached to the padding from the back side, and has no visible attachment points on the front.

 

 

6. Shoulder Bells: The silver shoulder bells are made from a sturdy, solid material. They are curved to follow the shape of the upper arms. Brown leather straps are used to hold the shoulder bells in place.

 

 

7. Flak Vest: The dark charcoal flak vest has vertical lines quilted onto the front and back. The partial sleeves are vertically quilted. The vest is long enough to stay tucked into the obi sash. The vest may be constructed with leather, a leatherette material, or a heavy, medium sheen fabric such as tackle twill.

 

 

8. Shirt: The long sleeved shirt is made of a matte black fabric. The shirt is form-fitting.

 

 

9. Gloves: Black leather gloves are worn over the sleeves of the shirt. The gauntlet style gloves have no buckles or extra decoration.

 

 

10. Belt: The black leather belt is worn at a slight angle, as if the lightsaber worn on the right is pulling that side down. The base belt is approximately 8 cm wide. Two thin belts, each approximately 2.5 cm wide, are worn over the base belt. These belts are held in place with black leather belt keepers which are spaced at intervals around the waist. Both of the small belts have a side-release buckle at the center front. A pentagon shaped silver plate is located just to the right side of the side release buckles. It is as wide as the base belt, and it covers both of the smaller belts. A small black leather pouch hangs from the top of the belt to the left side of the side release buckles. A Covertec lightsaber clip is located on the right side of the belt. The belt closes in the back.

 

 

11. Obi: The obi is made of black leather or leatherette material. The center front area of the obi is slightly wider than the rest.

 

 

12. Skirt: The ankle length skirt is made of heavy black material. In the front, the skirt is closed at the waist. Below that, the front of the skirt hangs open. The inside of the skirt is lined with the same dark red fabric as the cloak.

 

 

13. Double Sash: Embellished sash pieces are worn beneath the skirt. These sashes hang directly beneath the front opening of the skirt. They are made with a light charcoal fabric that is decorated with very light gray edge trim and designs that match the reference images. The sashes are not part of the skirt, but they may be lightly tacked to the edge of the skirt material to keep them in place while the costume is worn.

 

 

14. Pants: Black pants with a relaxed fit are worn tucked into the boots.

 

 

15. Greaves: Vertically striped greaves similar to those worn by Anakin are worn over the front of the boots. The greaves are made with a charcoal color that is lighter than the color of the flak vest. Two black leather straps are wrapped around the top area of each greave to hold it in place.

 

 

16. Boots: The knee high black boots have no visible buckles or laces when they are covered with the greaves and boot armor.

 

 

17. Boot Armor: A silver armor plate is worn over the top of the boots. The plate is held in place by a dark charcoal colored strap that goes under the sole of the boot.

 

 

Costume Accessories:

 

18. Lightsaber: The hilt resembles the reference images for Starkiller's lightsaber. If the lightsaber has a blade, the blade is red in color.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...