Leaderboard

Black vest completed! For the pattern on this one, I went back to my bodice sloper and closed out the upper darts, shaped the front sides, and shortened it. Getting the right length and looseness took a little bit of trial and error, but was not too troublesome. Here's my pattern - I opted to not include side seams to keep it a little cleaner. I used black velvet (and that little boy's smiiiile) for my fabric. I finished the edges and armholes with black bias tape since it would be difficult and messy to roll under and hem all those curves. The finished product is shown below. I'm getting so close to the end - just two more pieces and one 3D print to go! 😄