WIP: BH21211 Sith Acolyte

[KENT]

Greetings from Japan!
I've been attracted to this costume for the past few years and wasn't sure when to start, but I think I'm going to start slowly.

ITEMS- 
Helmet/Armor: 3D Print from 3Demon - Just Started

Robe: Undecided. I may have to beg my wife to make it.
Neckseal: Same as above

Pouches: Same as above
Lightsaber: Undecided. It seems like a good idea to ask Vaders Vault.
Undersuit / Gloves / Shoes: Plan to find an appropriate one domestically.

 

As you can see, very little preparation has been done.
In the meantime, I'm going to print and prepare armor parts to motivate myself.
Is it permissible to have the data checked together if necessary?

Thanks in advance.
I would be honored to complete this project and join TFE.

Edited February 20 by KENT

[KENT]

Today I printed only one hand armor.

[KENT]

Now printing out some of the parts that seem to be OK.

The entire file is being verified and most of them look "OK". However, there were some areas of concern regarding the armor on the back of the hands, thumbs, elbows, and calves, so I asked the creator of the file to correct them. I hope he accepts...

 

 

Let me know if you notice anything!
The belt is being verified, including how they are manufactured, and the boots armor have not yet been fully verified.