-
Announcement
Welcome to the forums!
If you are a newly-approved member, make sure you check out the New Member Checklist!
If you are a Detachment member and can't see the member-only area, post here for access.
-DV
norrecv
-
Posts
2 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Posts posted by norrecv
-
-
Hey all! Just got ahold of a Mynock kit - figured I would post some pics as I build. This kit is very detailed, Its scary cutting into it and buffing.... Well worth the wait though.
I have a couple of parts Im awaiting from Taras - the helmet back etc, but figured I would get moving as far as I could!
I trimmed and cut everything for the most part this weekend, and started the polishing.
Little clean up on the mask - some small resin bits throughout the lines and curves, nothing a hobby knife can't handle!:
Almost there! I have to airbrush in the black for the inset areas, then steel wool the raised areas:
I went with the 220 grit sand paper followed by 000 and then 0000 steel wool. It didnt give me the gleam I wanted so went with some silver leaf Rub and Buff. That brought out a very metallic shine - almost too much... I will have to weather it down with some 0000 wool once I apply the acrylic wash...
Here is a before and after rub and buff - which one has been buffed? =P
Here is some progress from today:
Sith Acolyte Build (Mynock's Den Armor)
in Sith Acolyte
Posted
Here is some of the kit out of the box:
Here is the mesk first run, I polished it, then airbrushed in the black on the insets, polished the raised area with steel wool to clean it up. The black isnt popping like i hoped - maybe another pass... There was a bit of weathering added to the shoulders via airbrush, and of course filled in the cog.