Jump to content
  • Announcement

    Welcome to the forums!

    If you are a newly-approved member, make sure you check out the New Member Checklist!

    If you are a Detachment member and can't see the member-only area, post here for access.

    -DV

Dr. Aphra - Burgundy Lined Vest Varient


Kylo

Recommended Posts

Hey there! Submitting my Aphra today and I wanted to start a thread on what I see in this costume...

 

I know it may look a bit like the other Burgundy Vest varient we have started. this is a different costume from the holster to the cap to the vest. 

 

 

h9aEG35.jpg

 

lmGCmUJ.png

 

JvRCHc6.jpg

Edited by Amidala
Link to comment
Share on other sites

From the Various ref i have above ive pulled the following tattoo details from those images

 

 

4l94NME.jpg

Link to comment
Share on other sites

Thank you so much 

ChaosBria for the excellent original mockup. 

 

Aviator Cap


  • The aviator cap is light tan in color and made from leather or a leather like material

  • The cap fits snug on the costumer’s head

  • A padded, circular shape sits on either side of the head over the ears with visible stitching around the edge where they connect to the cap

  • The chin strap should have two small tapering buckles at the end  and is worn unbuckled.

  • The strap should hang no lower than the collar bone.
  • The front of the cap comes to a soft point at the center and arches around the headline

Hair


  • Hair is black in color.

  • Hair is loose beneath the cap with at least some hair visible on the sides.

  • Hair is no longer than the shoulders
  • Hair i
     
  • Shaggy unkempt bangs hang from the front of the aviator cap and sit at the sides

Goggles


  • The goggles are oval shaped
  • The frames of the goggles are a dark red and match the color of the vest
  • The strap should be black or burgundy and is ¾ of an inch wide
  • The goggles should be worn on top of the costumer’s head and above the cap.
  • Two silver hooks with a line down the center on either side of the goggles.

Vest


  • The vest is a dark red (wine or burgundy) in color and made from a medium weight fabric with no visible closure.
  • The vest is designed as follows:
  • *A line of trim  made from the the same material as the vest around all edges of the jacket including sleeves.
  • **The seams at the sides under the arm are lined with a single strip of trim
  • **Two lines around the bottom hem.
  • *A single line of trim verticle on the shoulder blades. 
  • **A single line of trim sits vertically across the breast

  • The back of the vest ends at the costumers back arch.

  • The vest is worn open .

Shirt


  • The shirt is a light to medium weight natural fiber,

  • The shirt sleeves end at the costumers upper bicep.

  • The collar is popped.

  • Color can be white, off-white, or cream

Optional: A long sleeved shirt of the same cut may be substituted(do you have reference for this design?)

Tattoo


  • Tattoos (via sleeve, make-up, or otherwise) mimicking Aphra’s circuitry design in black must be on the right arm.

  • These should be an assortment of straight lines which end in circles with a dot in the center

  • The lines and circles are of equal width and be no wider than half a centimeter

  • See Dr. Aphra reference chart for more information (insert link)

Gloves


  • Gloves are black, wrist-length, of a leather-like material.

  • Gloves are fingerless and cut off above the finger joint.

  • A band around the arm joint no wider than 3 inches. 

Pants


  • The pants should be plain denim and tight-fitting .

  • Color is a varying shade of blue from steel blue to bright blue. 

Boots


  • The boots are black with low heels of an inch or less.

  • No buckles or laces are visible. Zippers are permitted on the insides.

  • The boots are knee-high in height

Belt and Holster


  • The belt is made from plain, un-decorated brown or Dark Brown leather and is 2.5 inches wide.

  • The plain silver buckle is octangular and wide. The buckle sits flush with the belt and is 3.5 inches long, the buckle can be up to 1/4 of an inch wider than the belt itself.

  • The holster is made from the same plain brown leather. There is one narrow strap to secure the blaster and a small strap attached to the belt crossing onto the holster.
  • The holster is attached by a un decorated leather strap that is one inch wide. 

  • A small silver colored buckle end is attached to the main belt holding the holster. 

Optional:
 

DL-44


  • If present, the blaster should be an exact replica of a DL-44
Edited by Kylo
Link to comment
Share on other sites

ChaosBria actually drafted the CRL. 

 

THANK YOU!

Edited by Kylo
Link to comment
Share on other sites

Pic or it didn't happen Dawn.

 

 

Sent from my iPhone using Tapatalk

 

 

Shoo  shoo Greene

 

 

lf3HJr8.jpg

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...