Revan WIP: once you go EU, you never go back

[DarthCephalus]

So I am on the books with a Nihilus, but once you go EU, you never go back. I have been working on it for a while, and I think I finally have a workable Revan. To get it, I have 2 Revans worth of parts. Will likely be looking to sell the extra sometime soon. I want to do a Becoming Revan video before I do so I can look at different parts from different makers. Still need to adjust a piece of Velcro, change the cape tie, and submit for approval, but more or less a finished product i think.

[Malt]

Hello ! By the CRL : 

• The hood is full and encloses the face completely. The lower front section of the hood tucks under the chest armor.

I dont see it well in the pictures is it done this way ?

 

[DarthCephalus]

Not in the pictures. I need to adjust that, but am wondering by how much. The CRL for this costume is odd to me in a few ways. It seems to contradict. It says rings on the breast plate but shows clips. It says the piping is visible just above the plate but then says the hood will be there. It says the hood encloses the face completely, but that is not the case in the picture as it dips below the armor just past the black portion. The CRL says the caplet is not pleated but every single one I have ever seen on an approved costume and the one in the picture is. Mostly I have been going by the pictures and other approved costumes more than the text.

[Malt]

Ok no problem it éven changed since my build was approved. I would advice tout adjust your black fabric ( that hangs to the o ring) it seems a bit off. Maybe it's not long enough ?

How are your leather strip connected to the o ring ? It doesn't look like it "hangs" on the pics 

Great job otherwise !

[DarthValkyria]

On 4/26/2018 at 9:59 PM, DarthCephalus said:

Not in the pictures. I need to adjust that, but am wondering by how much. The CRL for this costume is odd to me in a few ways. It seems to contradict. It says rings on the breast plate but shows clips. It says the piping is visible just above the plate but then says the hood will be there. It says the hood encloses the face completely, but that is not the case in the picture as it dips below the armor just past the black portion. The CRL says the caplet is not pleated but every single one I have ever seen on an approved costume and the one in the picture is. Mostly I have been going by the pictures and other approved costumes more than the text.

That's because the CRL was updated and before the photos could be uploaded, the hard drive that they were stored on was corrupted, so we are just waiting for new photos, lol.

Otherwise, the main photo is updated and complete.

[DarthValkyria]

As for the hood, you want to pull the panel edges in towards the middle of the chest so they slightly overlap and give the illusion of being one piece. Also, I would take a small piece of velcro and attach it so that the edge of the hood sits just above the eye slit.