Jump to content
  • Announcement

    Welcome to the forums!

    If you are a newly-approved member, make sure you check out the New Member Checklist!

    If you are a Detachment member and can't see the member-only area, post here for access.

    -DV

Getting Revan ready for approval


larryluftwaffe

Recommended Posts

Hello all thank you for your help on my build it's been absolutely invaluable I ended up buying my armor set from Wicked Armor and added a few touches of my own to make it work for me, and I think I'm ready to start the approval process and I was wondering besides the front-back-side views is there any other angle or detail pictures I need to take?

 

I have a picture of the rough test fitting attached here

So far what I know needs to happen is:

I need to drop the ring down a few inches to line the sash up with the bottom of the hakama,

I need to get the capelet and hood to sit evenly and then pin them together under the armor, and

I also need to be wearing the boots, other than that is there anything you guys can think of?

 

any criticism would be welcome!

I'll also be posting up all of the pieces in my WIP thread to make sure the individual parts are going to be okay.

post-4138-142759263082_thumb.jpg

Link to comment
Share on other sites

I've also done the same for the rings on the lower armor.

The ones that came with the armor were just key rings, so I had to swap those out too.

But I realized that I may have made the loops a tad too short so I'm likely going to re-tie them and give them a little bit more hang.

post-4138-142759263258_thumb.jpg

post-4138-142759263327_thumb.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...