Jump to content
  • Announcement

    Welcome to the forums!

    If you are a newly-approved member, make sure you check out the New Member Checklist!

    If you are a Detachment member and can't see the member-only area, post here for access.

    -DV

Mara Jade Harness questions/WIP


corsec

Recommended Posts

So I'm working on several laser cut kits for Mara Jade. I have the harness almost done. I'm making a prototype for a friend but looking to put these into production. So I have a few questions on the design.

 

2015-02-11%2016.54.59.jpg

 

Here is a shot of the almost complete piece. The bit in question is the raised center bit with the notches in it. Most of the costumes I have seen are using something a lot taller. However the reference I have looks thinner.

 

attachment.php?attachmentid=437924&d=1423695742&thumb=1

 

Is it just a case of preference or am I missing a reference for it?

 

Its laser cut MDF so I can layer it and have the straps actually anchored into the piece.

 

2015-02-11%2016.55.16.jpg

 

I'm also working on a holdout blaser kit. The prototype is done but I have a lot of adjustments to make.

 

2015-02-11%2017.02.56.jpg

 

Here is the kit unfinished.

 

2015-01-31%2014.04.12.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...