Jump to content
  • Announcement

    Welcome to the forums!

    If you are a newly-approved member, make sure you check out theĀ New Member Checklist!

    If you are a Detachment member and can't see the member-only area, post here for access.

    -DV

corsec

Forum Members
  • Posts

    2
  • Joined

  • Last visited

corsec's Achievements

0

Reputation

  1. The Choices of One suit is cool. I might have to look into experimenting with my laser and craft foam to make those shoulder pads. I was working on the green suit ones. I have those almost done. Still working on getting my foam skills up. I just finished a blacksuit harness for a friend. Your one of the ladies who did the Thermo Plastic workshop in Pensacola right?
  2. So I'm working on several laser cut kits for Mara Jade. I have the harness almost done. I'm making a prototype for a friend but looking to put these into production. So I have a few questions on the design. Here is a shot of the almost complete piece. The bit in question is the raised center bit with the notches in it. Most of the costumes I have seen are using something a lot taller. However the reference I have looks thinner. Is it just a case of preference or am I missing a reference for it? Its laser cut MDF so I can layer it and have the straps actually anchored into the piece. I'm also working on a holdout blaser kit. The prototype is done but I have a lot of adjustments to make. Here is the kit unfinished.
×
×
  • Create New...